Cleaning
Clean the bldet with a sponge or soft
Cloth with diluted kitchen detergent or glass cleaner. Do not use harsh petroleum products'or anything abbrasive. Avoid using chlorine or bleach for cleanlng.
Cleaning the Nozzle
Pull out the nozzle genty and use a smoothcloth or sponge or toothbrush with kitchendetergent to clean the nozzle.
Nozzle Replacement
1. Refer to figure A, pull out the tube and do not release .With your other hand, grasp the old nozzle and pull straight out 2. Refer to figure B, insert the new nozzle into the tube along the corresponding slot3. The nozzle replacement is completed.
Correcting Water Leaks
1. lf water leaks from either end of the water hose(s) or T-adapter,re-tighten the nuts to stop water from leaking. 2. lf a leak persists,turn off the T-adapter and water supply until theleak is stopped. Call customer service if you need assistance.
Self Diaonosis And Trouble Shooting
Status | Cause | Solution |
Water pressure lstoo low duringoperaton | 1.Lov water pressure of the unit | During use, turn the knob to the madmum setting |
2.Low water pressure of water supply | Vhen water supply pressure ls lower than 0.7kgf/cm, contactlocal department for walor pressure question | |
No water comes outduring WASH or BIDET | 1.Water shut-of valve is turmed off | Turn on the water shut-of valve |
2.Nozzle head ls blocked | Take off and clean the nozzle head | |
3.Extermal water pressure is low | ncrease external water pressure | |
Water dropping from bowl when using the unit | Water supply pressure ls too high | The maximum water pressure of the unit is 0.8 MPa. lfwater supply pressure ls hlgher than 0.8 MPa, pleasecntac local department for water pressure queston. |